LinxVIEW论坛-斯科道

标题: LINX人工安装过程 [打印本页]

作者: Scadao 时间: 2019-5-23 20:11
标题: LINX人工安装过程
本帖最后由 Scadao 于 2019-5-23 20:16 编辑

LINX人工安装过程

Installation Steps

Add the MakerHub software repository address to the target:
sudo sh -c 'echo "deb http://feeds.labviewmakerhub.com/debian/ binary/" >> /etc/apt/sources.list'

Get the list of available software from the MakerHub repository:
sudo apt-get update

Install the LabVIEW target support:
sudo apt-get install -y --force-yes lvrt-schroot

You should be ready to go!

欢迎光临 LinxVIEW论坛-斯科道 (http://iiotview.com/)